Longfield 30-Spline Birfield/Axle Super Set (Lf70/Rj70/Bundera) Gun Drilled
Manufacturer part number: 303347-1-KIT
Our price on this product is so insanely low, they won't allow us to show it to you until you add it to your cart. Don't worry - you can always remove it...
Longfield™ LJ70/RJ70 Gun Drilled 30-Spline 4340 Chromoly Super Set
The Longfield™ Gun Drilled 30-Spline Birfields are made out of 100% chromoly and are precision polished to remove any imperfections that may cause stress risers. The internals of the birfield are also made from 4340 chromoly and are dual heat treated for superior strength.The birfield has a M8 grease zerk at the end of the stub shaft and is gun drilled through the center of the birfield to allow for grease to pass through the zerk fitting and into the internals. This will save you precious time by eliminating the need to disassemble your axle just to service your birfields.
The Gun Drilled 30-Spline Birfields also have as hallow relief near the splines on the stub shaft known as a Machined Spline Saver. The Machined Spline Saver eliminates stress concentrations caused by grooving from the tool that makes the splines on the stub shaft. The stress concentration from the spline groove is a common failure point on birfield stub shafts.
The axle shafts are also made out of 4340 chromoly steel.
We understand that once you upgrade your axles,the next weak link is your hub gears, so we decided to include our Chromoly Inner Hub Gears at no additional cost!
Note: Inner Hub Gears will only work for manual locking hubs.
- Made out of 100% chromoly and are precision polished to remove any imperfections that may cause stress risers
- Birfield housing is made out of forged 4340 chromoly steel
- Internals of our Longfield™ birfields are made out of 4340 chromoly steel and then dual heat-treated for superior strength
- Machined spline saver to eliminate stress concentrations from the spline groove
- Gun drilled to create grease passage through the birfield
- M8 grease zerk at the end of stub shaft for easy greasing of the birfield
- The axle shafts are also made out of 4340 chromoly steel
|303310-1-KIT||Short Side Shaft||16-5/16"|
|303311-1-KIT||Long Side Shaft||30-1/4"|
- NON-US MODELS: Toyota Land Cruiser II, Bundera, Prado (70 Series Only), LJ70, LJ71, LJ73, LJ74, LJ78, RJ70, RJ73, RJ78, KZJ70, KZJ71, and KZJ77